kann ich im sockel370 ppga einen celeron ab: 800mhz fcpga einbauen? Spannung lt manual 3,3V, lt Systemtest auch Spannung 5 V???
Archiv Prozessoren 8.660 Themen, 54.742 Beiträge
(Anonym) ***mishy*** „cpu celeron pga 466mhz im elite mainboard p6bat-a+ baujahr? End“
Offensichtlich hast du die Revision 1.xx, denn 2.xx hat einen fcpga-Sockel. Aber dennoch kein Problem, siehe diesen Auszug aus der Elitegroupseite:
http://www.ecsusa.com/ecsusa/www.ecs.com.tw/products/p6batap.htm
The P6BAT-A+ is a full-sized ATX board measuring 305x220mm and using 4-layer printed circuit board. The P6BAT-A+ has a special design feature so that it includes a Slot-1 processor slot and a PPGA (Plastic Pin Grid Array) Celeron Socket-PGA370 processor socket. This feature means that you can install the mainboard with either a Pentium-III cartridge, a Pentium-II cartridge, the SEPP (Single Edge Processor Package) Celeron cartridge, or one of the new generation PPGA Celeron processors. In addition, the mainboard supports a 66 MHz memory bus, or a 100 MHz memory bus, so you can use inexpensive 66MHz memory chips, or higher-performance PC-100 memory chips. The board is installed with an integrated PCI-3D sound system and has a full suite of I/O ports. Seven expansion slots are available for system development and hardware monitoring is supported. This board allows complete flexibility. System integrators can choose the high-performance Slot -1 processor or the inexpensive PPGA Celeron processor according to the system requirements and the price/performance comparison of the two kinds of processor.
PROCESSORS
SECC2 Pentium III up to 850MHz(100MHz FSB), Pentium II
Celeron PPGA up to 533MHz
CHIPSET
Elite BX
CMI8738 PCI 3D Audio Chip on board
MEMORY
Three 168-pin DIMMs
Maximum: 384MB
Du nimmst einfach einen fcpga-Slot1-Adapter.
