Hi Hex,
generell sollte über das Menue intuitiv der Weg gefunden werden können. Die Netzwerk Konfig wird aber erst ausgegeben wenn auch eine NW-Karte im Drucker steckt.
Ein Klick und die Suche beginnt:
http://h20000.www2.hp.com/bizsupport/TechSupport/Home.jsp?locale=en_US&prodTypeId=18972&prodSeriesId=25487
Ein wenig Stöbern bringt dann folgendes zutage:
Resetting the HP Jetdirect to factory defaults
In some cases it is helpful to start with default HP Jetdirect configuration. Often, resetting and reconfiguring the print server will correct any problems. Resetting the print server is useful in the following conditions:
The HP Jetdirect needs to be reconfigured from a previous network configuration or from an inadvertently incorrect configuration.
The HP Jetdirect is in an error state that cannot be resolved by any other means.
To clear passwords, old IP addresses, or old NetWare configurations.
To help discover the HP Jetdirect with HP software such as the Install Network Printer Wizard.
Before resetting the HP Jetdirect (known as a cold reset), print a Configuration page as described in the Configuration page section below, because resetting an HP Jetdirect print server to factory defaults (known as a cold reset) will erase all previous configurations and may require network administrative knowledge, permissions, and access to reconfigure it.
The factory defaults of a Jetdirect print server typically include an IP address of 192.0.0.192 or 169.254.xxx.xxx, unless a DHCP or BootP server assigns the addresses on your particular network. (A cold reset also allows the HP Jetdirect to broadcast DHCP and BootP packets, which will allow it to be configured by a DHCP or BootP server.)
The TCP/IP status on the Configuration page should be Ready, and IPX/SPX status should be Not Configured, though some Jetdirects may be Ready.
Most internal HP Jetdirect print servers can be reset to factory defaults (or cold-reset) by turning the printer off and holding down the ONLINE or GO button while turning the printer back on. The printer control panel display should read Cold Reset, or Restoring Factory Settings, or something similar.
Click here for more information about restoring the defaults of a Jetdirect in various printers.
To cold reset an HP Jetdirect external print server, unplug the power cord from the HP Jetdirect device, and hold down the TEST button for 5 to 30 seconds while plugging in the power cord.
Embedded Jetdirect Inside print servers: The method to reset an internal embedded Jetdirect Inside print server to factory defaults (cold reset) may vary from printer-to-printer. See the printer documentation for assistance resetting the printer and the embedded Jetdirect Inside print server back to factory defaults.
Some HP Designjet plotters cannot reset an HP Jetdirect device. HP Web Jetadmin can be used to reset the IPX/SPX settings; Telnet can be used to reset the TCP/IP settings. Some newer HP Designjet printers (500, 800, 1050c, 1055cm, 5000, etc.) have a reset option in the control panel menus.
Aber hier stehts genauer:
http://h20565.www2.hp.com/portal/site/hpsc/template.PAGE/public/kb/docDisplay/?javax.portlet.tpst=ba847bafb2a2d782fcbb0710b053ce01&javax.portlet.prp_ba847bafb2a2d782fcbb0710b053ce01=wsrp-navigationalState%3DdocId%25253Demr_na-bpj02738%25257CdocLocale%25253Den_US&javax.portlet.begCacheTok=com.vignette.cachetoken&javax.portlet.endCacheTok=com.vignette.cachetoken
Servus, f_2
fichti_02
hexagon
