hallo,
eine bekannte von mir hat einen hp-pc (p4, 2 gb ram, 2ghz) , intel-chipsatz (grandsdale),
mit folgendem bios: compaq 786c1, version 02.15, datum 08/07/08.
ich möchte den fifi gern win7-32-fähig machen, aber das bios ist verschlüsselt,
, und der schlüsselwisser macht grade eine antarktisexpedition, somit geht kein update.
gibts da irgendeine möglichkeit?
mfg felix
Alpha13 felixfix „hallo paperle, der cmos- jumper ist ein kleines gelbes ...“
Power-On / Setup Password
These systems include a power-on and setup passwords, which may be enabled or disabled
(cleared) through a jumper on the system board. The jumper controls a GPIO input to the 82801
ICH6 that is checked during POST. The password is stored in configuration memory (CMOS)
and if enabled and then forgotten by the user will require that either the password be cleared
(preferable solution and described below) or the entire CMOS be cleared (refer to section 4.4.1).
To clear the password, use the following procedure:
1. Turn off the system and disconnect the AC power cord from the outlet and/or system unit.
2. Remove the cover (hood) as described in the appropriate User Guide or Maintainance And
Service Reference Guide. Insure that all system board LEDs are off (not illuminated).
3. Locate the password clear jumper (header is labeled E49 on these systems) and move the
jumper from pins 1 and 2 and place on (just) pin 2 (for safekeeping).
4. Replace the cover.
5. Re-connect the AC power cord to the AC outlet and/or system unit.
6. Turn on the system. The POST routine will clear and disable the password.
7. To re-enable the password feature, repeat steps 1-6, replacing the jumper on pins 1 and 2 of
header E49.
!!!
